Razer Blade Pro 17 Disassembly

In this guide, I’ll disassemble Razer Blade Pro, I will remove the bottom case, SSD, battery, wireless card, heat sink, cooling fan and motherboard. Refer to this guide, you can upgrade and repair your Razer Blade Pro.

There are fourteen screws securing the bottom case.

Remove all screws from the bottom case.

Pry up and remove the bottom case.

Now, you can get access internal components, including hard drive, battery, USB board and cooling fan.

Razer Blade Pro uses a lot of black tape fixed cable. It is not very professional.

Disconnect the battery connector from the motherboard.
Pry up and remove the battery.

Razer Blade Pro comes with a 14.8v, 5000mah, 74wh li-ion battery.

HGST 500GB 5400RPM hard drive

Remove the black tape covered the SSD.
Disconnect two cables connecting to the USB board

Remove the SSD.

Razer Blade Pro’s USB board

Unplug two wireless antenna cables.
Remove the screw securing the wireless card.

11 Comments

Leave a Reply to Brad Cancel reply

Your email address will not be published. Required fields are marked *

6  +  4  =